![]() ![]() The settings for the DIM function are found on the CONTROL ROOM strip. If the Monitor volume knob on your Apollo is blinking and you have no audio output, then you may have the DIM function enabled with the DIM AMOUNT set too high in the Console application. On Apollo, Apollo 8, and Apollo 8p, this is done by setting the source of one of the Cues (typically CUE 1, as shown in the picture above) to MON, and then selecting HP1 and/or HP2 to the right of that Cue. On Apollo Twin this is done by selecting the MON button to the right of HP (shown in the picture above). ![]() In most cases the Headphone (HP) source should be set to MON. The Headphone (HP) output source is set on the CUE OUTPUTS popover, which can be accessed by clicking the CUE OUTPUTS button on the right hand side of the Console window, just below the CTRL ROOM button.ĬUE OUTPUTS popover (Apollo, Apollo 8, Apollo 8p) This means that any audio routed to the MON L and MON R outputs (or outputs 1 and 2 in DAWs that don't use I/O labels) can be heard through the Monitor L/R outputs of the Apollo. In most cases the Monitor Source should be set to MONITOR. Monitor source settings in the CONTROL ROOM strip The Monitor output source is set on the CONTROL ROOM strip which is accessed by clicking the CTRL ROOM button on the right hand side of the Console window. ![]() Not getting any sound from the Monitor or Headphone outputs of your Apollo? Here's what to check first:įirst check your SOURCE settings in the Console application. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |